The Fixed Assets Register (FAR) is the accounting record most Nepali SMEs postpone building until an audit forces them to. That is a mistake — the FAR is not a bureaucratic form; it is the operating record that connects a physical thing in your office to a number on your balance sheet, and it drives depreciation, insurance, disposal accounting, tax positions and internal control at the same time. This guide walks through building a FAR from scratch, running it properly month after month, and keeping physical reality and the ledger reconciled — with a copy-ready Excel schema, worked examples, and Nepal-specific depreciation under Schedule 2 of the Income Tax Act 2058.

Key takeaways

  • A FAR is required by both the Income Tax Act 2058 (Schedule 2) for block-wise WDV depreciation and by NFRS/NAS 16 for financial-statement disclosures — you cannot get either right without it.
  • Every asset needs a unique asset code, a physical tag, and a row in the register — no exceptions. If it does not tie back, it does not exist.
  • Nepal's tax depreciation uses five blocks (A–E) with WDV rates 5% / 25% / 20% / 15% / 10% respectively, and a 1/3rd rule for mid-year additions.
  • Book depreciation (NAS 16 straight-line) and tax depreciation (Schedule 2 WDV) will not match — that is normal, and creates deferred tax.
  • Physical verification once a year is the minimum; rolling verification of high-value or mobile assets each quarter is the standard we recommend.

Why the FAR matters

A FAR is doing four jobs at the same time:

The asset lifecycle at a glance

The asset lifecycle

Acquisition PO, GRN, invoice Capitalisation Cost + freight + install Tag & code Sticker on asset Depreciate Book + tax Verify Physical count Dispose Sale/scrap Every step leaves a row in the FAR — nothing exists off-register.

The FAR is the source of truth across the whole lifecycle. Each step should update at most one row of the register.

Building the register from scratch — the schema

Every FAR — whether in Excel, Tally, or an ERP — needs the same core columns. Start with these and you can always add more later:

ColumnPurpose
Asset CodeUnique ID — the primary key of the register. Never reused.
DescriptionPlain-language what-is-it. "HP LaserJet Pro M404dn, Sn: XY123."
Category / BlockBlock A / B / C / D / E under Schedule 2, and your finer book category.
LocationBuilding, floor, room / desk / vehicle.
CustodianNamed employee or department currently responsible.
Supplier + Invoice No.Ties the asset back to the purchase document.
Date of PurchaseInvoice date. Used for warranty and 1/3rd rule.
Date Put to UseWhen it was actually installed/commissioned — controls tax depreciation start.
Original Cost (NPR)Invoice cost + freight + install + non-refundable duties. Excludes VAT if input credit claimed.
Useful Life (yrs)NAS 16 estimate for book depreciation.
Salvage ValueExpected residual — usually zero for tax; small for book.
Book Depreciation MethodSLM (typical) or WDV.
Tax BlockA / B / C / D / E per Schedule 2.
Opening WDV, Additions, Depreciation, Closing WDVYearly columns; drive the tax computation.
Physical Verification DateLast time someone laid eyes on the asset.
StatusIn Use / Idle / Retired / Sold / Written-off.
Disposal Date, Sale Proceeds, Gain/LossPopulated on retirement.

Asset coding and tagging

A good code makes the register self-documenting. A workable structure for a small Nepali business:

WL-KTM-B-014 — where WL is your entity, KTM is the location, B is the tax block, 014 is a running serial.

Depreciation — Schedule 2 blocks A–E

Under Schedule 2 of the Income Tax Act 2058, assets are grouped into five pools (blocks), each with its own WDV rate. The block, not the individual asset, is what depreciates:

Nepal tax depreciation rates (WDV, per block)

Block A — Buildings, structures 5% Block B — Computers, office equipment, fixtures 25% Block C — Automobiles, buses, minibuses 20% Block D — Construction plant, other business assets 15% Block E — Intangibles / mineral rights See §

Source: Income Tax Act 2058, Schedule 2. Block E depreciation is amortised over the useful life of the intangible.

Every fixed asset must be assigned to exactly one block. If you cannot decide between two blocks for a particular asset — say, a specialised piece of testing equipment — the safer position is usually the higher-rate block, but confirm with your auditor.

Additions to a block during the fiscal year do not get a full year of depreciation. Schedule 2 uses a three-tier rule based on when in the year the asset was put to use:

This is a Nepal-specific convention — do not import the Indian half-year rule or the international mid-month convention. It matters because most acquisitions land near the fiscal-year end (Chaitra–Ashadh), and getting the fraction wrong understates or overstates deductible depreciation.

Worked example — a Kathmandu SME's first year

Suppose a consulting firm buys the following assets during FY 2082/83:

AssetCost (NPR)BlockDate put to useDepreciable amount
Office fit-out15,00,000A (5%)Shrawan (early)Full (15,00,000)
Laptops × 57,50,000B (25%)Bhadra (early)Full (7,50,000)
Server4,00,000B (25%)Mangsir (mid)2/3 = 2,66,667
Delivery van25,00,000C (20%)Baisakh (late)1/3 = 8,33,333

The FY 2082/83 tax depreciation is:

The 1/3rd rule is not a rounding convention — it is a real reduction in your first-year deductible depreciation. Plan capex acquisitions in the first four months of the year where you can.

Book vs tax depreciation — deferred tax

Book depreciation under NAS 16 is typically Straight Line over estimated useful life (e.g., laptops 3 years, servers 5 years, buildings 30-40 years, vehicles 5-7 years). Tax depreciation under Schedule 2 is WDV pool-based. These will almost never match. The difference is a timing difference giving rise to deferred tax under NAS 12.

Book (NAS 16 SLM)Tax (Schedule 2 WDV)
MethodStraight Line (usual)Written Down Value
BaseCost − residual, per assetBlock WDV as a pool
Rate driverEstimated useful lifeSchedule 2 fixed %
First-year fractionPro-rata from month of use1/3rd rule (full / 2/3 / 1/3)
Disposal impactIndividual asset gain/lossReduces block WDV

Monthly maintenance workflow

  1. Additions: Every asset invoice through the AP cycle should generate a FAR row before it hits the general ledger. Never post to Fixed Assets without a code being created.
  2. Transfers: If a laptop moves from one employee to another, update the Custodian column and log the change.
  3. WIP/CWIP: Track assets under construction separately; capitalise (move to FAR proper) on the date the asset is put to use, not on the date of the final invoice.
  4. Book depreciation: Run automatically monthly through your accounting software or an Excel formula linked to the FAR.
  5. Reconciliation: At month-end, tie the FAR closing balance to the ledger (Fixed Assets − Accumulated Depreciation). A recurring 1% mismatch is a broken FAR.
  6. Insurance: Renew insurance schedules against the FAR — undervalued cover is a common gap.

Physical verification — how, and how often

Disposals, transfers and impairment

The Excel schema you can copy

Below is a minimal, working-quality FAR you can drop into Excel today. Adjust as your business scales — but do not skip any of these columns:

CodeDescriptionBlockLocationCustodianPurchase DatePut to UseCost (NPR)Life (yr)Book MethodBook Op. WDVBook Dep.Book Cl. WDVTax Op. WDVTax Add.Tax Dep.Tax Cl. WDVLast PVStatus
WL-KTM-A-001Office fit-outAHG-2FAdmin2082-04-052082-04-151,500,00010SLM—150,0001,350,000—1,500,00075,0001,425,0002082-12-30In Use
WL-KTM-B-014Server Dell R750BHG-2F-ServerIT2082-08-202082-08-25400,0005SLM—80,000320,000—266,66766,667200,0002082-12-30In Use

Handy Excel formulas for the register:

Frequently asked questions

Can I keep the FAR only in Tally Prime?

Tally's built-in Fixed Assets module handles the ledger side, but it does not natively track custodian, location, or verification history. Most Nepali businesses keep Tally for the accounting and Excel/ERP for the operational FAR, reconciled monthly.

What about assets below a de-minimis (NPR 5,000, 10,000)?

Many businesses have a policy to expense assets below a threshold (say NPR 5,000 per item). This is an accounting policy choice and must be applied consistently. For tax, Schedule 2 does not exempt low-value assets — technically they still enter the block; in practice, immaterial items are expensed.

Can VAT be capitalised into asset cost?

Only if you cannot claim input credit on it. VAT-registered businesses that use the asset in taxable supplies exclude VAT from the capitalised cost.

How do I handle a fully-depreciated asset that is still in use?

Keep it in the FAR at Rs 1 or its salvage value, with status "In Use." Retire only on physical disposal. It is not unusual for well-run FARs to carry 10-year-old items at nominal value simply for control.

What if my company file has never had a proper FAR?

Do a "day-zero" physical count, build the register bottom-up, back-solve depreciation from purchase invoices where available, and open the register with a management-approved reconciliation to the ledger. It is uncomfortable but one-time; done properly, you are set for a decade.

Getting your FAR set up correctly

Building a FAR from scratch usually takes 3–5 working days for a small business — most of it physical counting and back-solving purchase history. Doing it once, properly, saves you every year at audit.